Brown wood oil evens out the colour of hardwood or thermally treated wood
Charming ready-mixed grey colour!
Modern black colour for terrace structures
Valtti Furniture and Decking Oil
Pre coloured wood oil
An easy and durable choice for oiling terraces, jetties and wooden furniture. The oil is absorbed readily into the wood.
Freshens up old surfaces
Available in pre-mixed grey, black or brown, the oil slows down the degrading effects of sunlight.
Keeps wood in condition
Wood oil is very easily applied and requires very little preparation prior to re oiling, just brush on a coat whenever your timber starts to look tired.
As good as new
An old, soiled wood surface darkened over time can be treated simply and easily with Valtti Furniture and Decking Oil Black. The deep and even colour, with no dark stains, will dramatically change the appearance of the wood and make it look visibly newer.
(Previous date 01.01.2012)
Valtti Furniture and Decking Oil Brown, Grey and Black
5-7 m2/l on old and worn wood surface
7-15 m2/l on new surface or wood surface in good condition
The surface to be painted, the paint and the air temperature must be at least +5°C, and relative humidity below 80% during painting and drying
Remove all dirt, dust and loose material from the surface. Wash off mould with Homeenpoisto (Mould Removal) or Tehopesu (Super Clean) according to instructions.
Surfaces previously treated with wood oil:
Remove loose material from the surfaces with a scraper or wire brush. Clean and wash if necessary with Homeenpoisto (Mould Removal) or Tehopesu (Super Clean) according to instructions. If a clear film remains on the surface, remove it before treatment. Allow the surface to dry, as moist wood does not absorb oil, which dries slowly in damp conditions.
according to Regulation (EC) No. 1272/2008
Safety data sheet
InstructionsConsumption varies depending on the surface to be treated and its condition. Absorption is affected e.g. by the surface roughness, moisture content level of timber and porosity. For example, log surface that has been untreated for a long time takes a lot more wood finish than a new surface to be treated.
When calculating the consumption, note that the consumption for round logs is 1.5 times higher than normal. Please also note the corner joints in the surface area.